Daewoo DWC-ED1232 Manuel de service télécharger pdf (Page 48)

Perform a test run to identify any water leaks or abnormal noise.

After installation

7. Installation

- Determine the installation site after discussing

the site structure with the customer.

Breast-high location is convenient for installation.

* Installation and use are convenient with access

to water supply, drainage, and electric outlets.

1. Determine the location for installation

- Use a level meter for attachment.

- Attach a guide and mark the hole spot.

* Attach the manual in consideration of actual

product size.

3. Attach installation instruction manual

- Knock on the wall with your hand to check the

existence of retaining wall inside.

* Install the washer on an even wall.

2. Inspect wall

- Fix set anchors with an anchor hammer.

* Redo the fixation if the anchor cap protrudes

above the wall surface after fixation.

6. Fix set anchors

- Connect the power cord as requested by the

customer (upward, downward).

- Attach a connector and fix the grounding wire.

Fix the upward power cord tight with clamp cords.

* Fix the grounding wire with grounding screws.

* Do not ground multiple grounding wires in a

single place.

8. Connect the power cord

- Insert the inlet hose until the elbow makes a

snapping sound.

Connect the clamp inside the synchronous motor after

fixing the drain house to the synchronous motor.

* Connect hoses properly to prevent leaks.

* Insert the inlet/drain hoses into the back holes

after connection.

7. Connect inlet and drain hoses

The washer is recommended to be installed by a professional service engineer.

Install the washer without plugging in the power cord.

Before installation

- Notch below the marking hole.

- Drill a hole perpendicular to the wall surface.

* Do not drill a hole on the edge of wall tile.

* Do not drill a hole right below the faucet.

4-1. Drill a hole through tile

- Insert set anchors into holes.

- Set anchors are included in the product

package.

* Insert set anchors to the end of holes.

* The set anchor bolt must be 75mm long or

longer above the wall.

5. Insert set anchors (4 holes)

- Set the hammer drill perpendicular to the wall

surface and then drill a hole into the retaining

wall.

* Follow the instructions on the diameter and

depth specifications for the hole.

* Remove dirt from inside the hole.

4-2. Drill a hole into the retaining wall

1 2 ... 43 44 45 46 47 48 49 50 51 52

Commentaires sur ces manuels

Pas de commentaire

Daewoo DWC-ED1232 Manuel de service Page 48

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Daewoo DWC-ED1232